![]() ![]() Keep the AC plug connected to the AC outlet and pry out the battery holder at the bottom of the unit using a slender rod, such as a screwdriver.Note: If “AM 12:00” flashes in the display when the unit is connected to AC outlet for the first time, the battery may be weak. Use of another battery may cause a fire or explosion. Replace the battery with a Sony CR2032 lithium battery. If a power interruption occurs while the battery is weak, the current time will be initialized. When the battery becomes weak, “ ” appears in the display. The battery keeps the clock operating in the event of a power interruption. To keep good time, this unit contains one CR2032 battery inside of the unit as a backup power source. Note: If you lose the supplied screws, please purchase #10 or M5 screws. Install the unit with the supplied mounting screws.The unit can be installed without the spacer. L) by turning the spacer counterclockwise (See Fig.First set the L mark to the dot which becomes the lowest position, then you can adjust the height in 4 steps (H When the cabinet door overhangs the shelf and obstructs the unit, you can adjust the unit/shelf height.Use a drill to make the holes (size 6.5 mm diam., 9 /32 inch). Mark the position of the 4 holes by using the supplied template.Decide on the installation location and orientation of the unit based on the best reception that is possible (see “Improving the reception”).After installing the unit, do not pull down on it or hang something heavy on it.Make sure the unit’s four screws are fastened tightly.Never place objects between the top of the unit and the bottom of the cabinet.To reduce the risk of fire or electric shock, do not touch the AC power cord with wet hands.Install it where it will not be exposed to splashing by water, as this may damage the unit. Install the unit as far as possible from sources of noise (for example, a refrigerator, microwave oven or fluorescent lamp).Confirm that AM reception is acceptable before finally attaching the unit. The unit has a built-in ferrite bar antenna for AM radio reception. ![]() If the AC power cord has some slack, wind it around the cord hook so as to eliminate the slack. Be sure that the AC power cord has no slack during use of the unit, since the cord acts as an FM wire antenna.Do not use a converter or extension cord. Install the unit so that its AC power cord can be connected directly to a wall outlet.To reduce the risk of fire, do not place any heating or cooking appliance beneath this unit. Be sure that the cabinet that is used is sturdy enough to support the weight of the unit. Use tools carefully while installing of the unit.Installation of the unit requires two persons. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |